Note: I have
a lot of pictures on the following web pages. The OLDEST pictures are shown here, and the
pictures get progressively newer as you "turn" the pages.
Above Left: Part with secondary machining on it performed with an abrasive waterjet.
Above:
Pictures of two simple parts cut with an abrasive waterjet.
Above:
Pictures of two more simple parts cut with an abrasive waterjet.
Above Left: Scrap from part cut out of ceramic.
Above Right: You don't have to cut all the way through! While I would not purchase an abrasivejet for the sole purpose of etching, it can be fun for some artistic purposes. For best results, use low pressure so you don't cut so quickly. (More pictures like this are on the next page.)
Above: Cutting under water to reduce noise and splash.
Above: Precision machining insures a perfect fit!
Above: Some pictures of waterjet parts on display at a trade show.
Above Left: Some spooky looking medical device.
Above: Some alternative materials.
Above: part with lots of holes. Notice in the picture on the right that the pump was left on during traverses to save cycle time between holes.
Above Left: Consider doing pre-machining on an abrasive jet to remove excess material before final machining. This can save time and money.
Above Left: Tabs used to hold small parts in place.
(The waterjet pictures on this page are courtesy of OMAX Corporation . If you have pictures you want to contribute, let me know)